Updating To DayBack 10.27

Notes on our latest calendar for FileMaker 13,: DayBack
SeedCode Staff
SeedCode Staff
Posts: 98
Joined: Mon Aug 13, 2012 7:43 am
PostPosted: Tue Apr 03, 2018 4:00 pm
Please back up your file before making any changes.

Note: This script update fixes an edge case scenario and is not required for the update to run. Please update the script to keep your code base in sync but this is not a required change.

If you haven't already, navigate to the "Settings" tab in the calendar sidebar and click "Account Settings". Click "Check For Updates". This button should change to "Install Update" and inform you that version 10.27 is available. Click "Install Update".

The Changes

Update the following script in your DayBack file:

"SearchCSS (start)" REPLACE "=" with an ">=" on the exit loop script step as shown in the screenshot below:

Screen Shot 2018-04-03 at 11.14.53 AM.png
Screen Shot 2018-04-03 at 11.14.53 AM.png (70.46 KiB) Viewed 7297 times



Finishing Up:
Change the build number recorded in the database. Navigate to "File -> Manage -> Database" then go to the "CalendarInterface" table. Change the "BuildNumberCalc" calculation to read "10.27". Click "OK" to save those changes.

Then please run the "Upon Opening" script in your file. This will ensure all of the new settings load properly and the calendar loads with the correct data.

That's it, enjoy DayBack 10.27.

Return to DayBack Calendar for FileMaker

Who is online

Users browsing this forum: No registered users and 2 guests

cron
(855) SEEDCODE
[email protected]
Follow us: