Page 1 of 1

Updating To DayBack 10.46

PostPosted: Thu Dec 20, 2018 4:08 pm
by tanner
Please back up your file before making any changes.

If you haven't already, navigate to the "Settings" tab in the calendar sidebar and click "Account Settings". Click "Check For Updates". This button should change to "Install Update" and inform you that version 10.46 is available. Click "Install Update".

The Changes

In your file edit the script "Create Edit Delete Event ( SourceNo, Operation ) { Hide, DateStart , DateEnd , TimeStart ... }". Scroll toward the bottom and find "Set Variable" script step for "$sc_AdditionalFieldName" as shown in the image below. Edit the set variable step.

Screen%20Shot%202018-12-13%20at%202.34.35%20PM.png
Edit Additional Fields
Screen%20Shot%202018-12-13%20at%202.34.35%20PM.png (125.61 KiB) Viewed 3135 times


Now just as before replace the comma substitution with $sc_FieldSeparator. Make sure to save your changes to the script when done. Please Note: this might have already been done in your file. There were two DayBack releases that did not include this script change. If your file already looks like the screenshot below you are good to go.

Screen%20Shot%202018-12-13%20at%202.33.22%20PM.png
Substitute Field Separator
Screen%20Shot%202018-12-13%20at%202.33.22%20PM.png (26.89 KiB) Viewed 3135 times


Finishing Up:
Close the new DayBack file you used to copy the script contents from.
Change the build number recorded in the database. Navigate to "File -> Manage -> Database" then go to the "CalendarInterface" table. Change the "BuildNumberCalc" calculation to read "10.46". Click "OK" to save those changes.

Then please run the "Upon Opening" script in your file. This will ensure all of the new settings load properly and the calendar loads with the correct data.

That's it, enjoy DayBack 10.46.